Command Line Interface Guide

SNMP Commands 1595
Command Mode
Global Configuration mode
User Guidelines
If a DNS host name is entered instead of an IP address, the switch attempts
to resolve the host name immediately using DNS. Use the ip domain-lookup
command on page 496 and the ip name-server command on page 499 to
enable resolution of DNS host names.
Example
The following example enables SNMP traps for host 192.16.12.143.
console(config)# snmp-server host 192.16.12.143
Dell_powerconnect traps v2
snmp-server location
Use the snmp-server location command in Global Configuration mode to set
the system location string. To remove the location string, use the no form of
this command.
Syntax
snmp-server location text
no snmp-server location
• text — Character string describing the system location. (Range: 1 to 255
characters.)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
2CSPC4.XModular-SWUM201.book Page 1595 Monday, October 3, 2011 2:21 PM