Command Line Interface Guide

Command Groups 145
Captive Portal
boot auto-copy-sw allow-
downgrade
Enables downgrading the firmware version on
the stack member if the firmware version on the
manager is older than the firmware version on
the member.
GC
boot host autoreboot Enables rebooting the device (no administrative
intervention) when the auto-image is
successfully downloaded.
GC
boot host autosave Enables/disables automatically saving the
downloaded configuration on the switch.
GC
boot host dhcp Enables/disables Auto Config on the switch. GC
boot host retrycount Set the number of attempts to download a
configuration.
GC
show auto-copy-sw Displays Stack Firmware Synchronization
configuration status.
PE
show boot Displays the current status of the Auto Config
process.
PE
a. For the meaning of each Mode abbreviation, see Mode Types on page 79.
Command Description Mode
a
authentication timeout Configures the authentication timeout. CP
captive-portal Enables the captive portal configuration mode. GC
enable Globally enables captive portal. CPI
http port Configures an additional HTTP port for captive
portal to monitor.
CP
https port Configures an additional HTTPS port for
captive portal to monitor.
CP
show captive-portal Displays the status of captive portal. PE
show captive-portal status Reports the status of all captive portal instances
in the system.
PE
block Blocks all traffic for a captive portal
configuration.
CPI
Command Description Mode
a
2CSPC4.XModular-SWUM201.book Page 145 Monday, October 3, 2011 2:21 PM