Command Line Interface Guide

142 Command Groups
Tunnel Interface
distribute-list out Specifies the access list to filter routes received
from the source protocol.
RIP
enable Resets the default administrative mode of RIP
in the router (active).
RIP
hostroutesaccept Enables the RIP hostroutesaccept mode. RIP
ip rip Enables RIP on a router interface. IC
ip rip authentication Sets the RIP Version 2 Authentication Type and
Key for the specified interface.
IC
ip rip receive version Configures the interface to allow RIP control
packets of the specified version(s) to be
received.
IC
ip rip send version Configures the interface to allow RIP control
packets of the specified version to be sent.
IC
redistribute Configures OSPF protocol to allow
redistribution of routes from the specified
source protocol/routers.
PIP
router rip Enters Router RIP mode. GC
show ip rip Displays information relevant to the RIP router. PE
show ip rip interface Displays information related to a particular RIP
interface.
PE
show ip rip interface brief Displays general information for each RIP
interface.
PE
split-horizon Sets the RIP split horizon mode. RIP
a. For the meaning of each Mode abbreviation, see Mode Types on page 79.
Command Description Mode
a
interface tunnel Enables the interface configuration mode for a
tunnel.
GC
show interfaces tunnel Displays the parameters related to tunnel such
as tunnel mode, tunnel source address and
tunnel destination address.
PE
Command Description Mode
a
2CSPC4.XModular-SWUM201.book Page 142 Monday, October 3, 2011 2:21 PM