Command Line Interface Guide

Command Groups 135
distribute-list out Specifies the access list to filter routes received
from the source protocol.
ROSPF
enable Resets the default administrative mode of OSPF
in the router (active).
ROSPF
exit-overflow-interval Configures the exit overflow interval for OSPF. ROSPF
external-lsdb-limit Configures the external LSDB limit for OSPF. ROSPF
ip ospf area Enables OSPFv2 and sets the area ID of an
interface.
IC
ip ospf authentication Sets the OSPF Authentication Type and Key for
the specified interface.
IC
ip ospf cost Configures the cost on an OSPF interface. IC
ip ospf dead-interval Sets the OSPF dead interval for the specified
interface.
IC
ip ospf hello-interval Sets the OSPF hello interval for the specified
interface.
IC
ip ospf mtu-ignore Disables OSPF maximum transmission unit
(MTU) mismatch detection.
IC
ip ospf network Configure OSPF to treat an interface as a point-
to-point, rather than broadcast interface.
IC
ip ospf priority Sets the OSPF priority for the specified router
interface.
IC
ip ospf retransmit-
interval
Sets the OSPF retransmit Interval for the
specified interface.
IC
ip ospf transmit-delay Sets the OSPF Transit Delay for the specified
interface.
IC
maximum-paths Sets the number of paths that OSPF can report
for a given destination.
ROSPF
nsf Enables OSPF graceful restart. ROSPF
nsf helper Allow OSPF to act as a helpful neighbor for a
restarting router.
ROSPF
nsf helper strict-lsa-
checking
Set an OSPF helpful neighbor exit helper mode
whenever a topology change occurs.
ROSPF
Command Description Mode
a
2CSPC4.XModular-SWUM201.book Page 135 Monday, October 3, 2011 2:21 PM