Command Line Interface Guide

Command Groups 133
OSPF
show ip pim bsr-router Displays the bootstrap router (BSR)
information.
PE
show ip pim interface Displays PIM interface status parameters. If no
interface is specified, the command displays the
status parameters of all PIM-enabled interfaces.
UE or
PE
show ip pim neighbor Displays PIM neighbors discovered by PIMv2
Hello messages. If no interface is specified, the
command displays the neighbors discovered on
all PIM-enabled interfaces.
UE or
PE
show ip pimrphash Displays the rendezvous point (RP) selected for
the specified group address.
UE or
PE
show ip pim rp mapping Displays the mappings for the PIM group to the
active rendezvous points (RPs).
UE or
PE
a. For the meaning of each Mode abbreviation, see Mode Types on page 79.
Command Description Mode
a
area default-cost Configures the advertised default cost for the
stub area.
ROSPF
area nssa Configures the specified area ID to function as an
NSSA.
ROSPF
area nssa default-info-
originate
Configures the metric value and type for the
default route advertised into the NSSA.
ROSPF
area nssa no-redistribute Configures the NSSA Area Border router (ABR)
so that learned external routes are not
redistributed to the NSSA.
ROSPF
area nssa no-summary Configures the NSSA so that summary LSAs are
not advertised into the NSSA.
ROSPF
area nssa translator-role Configures the translator role of the NSSA. ROSPF
area nssa translator-stab-
intv
Configures the translator stability interval of the
NSSA.
ROSPF
area range Creates a specified area range for a specified
NSSA.
ROSPF
Command Description Mode
a
2CSPC4.XModular-SWUM201.book Page 133 Monday, October 3, 2011 2:21 PM