Command Line Interface Guide

Command Groups 127
IPv6 Routing
ipv6 pimsm register-
threshold
Configures the Register Threshold rate for the
RP router to switch to the shortest path.
GC
ipv6 pimsm rp-address Statically configures the Rendezvous Point (RP)
address of a PIM for one or more multicast
groups.
GC
ipv6 pimsm rp-candidate Configures the router to advertise itself to the
bootstrap router (BSR) as a PIM candidate
rendezvous point (RP).
GC
ipv6 pimsm spt-threshold Configures the Data Threshold rate for the last-
hop router to switch to the shortest path on the
router.
GC
ipv6 pimsm ssm Defines the Source Specific Multicast (SSM)
range of multicast addresses.
GC
show ipv6 pimsm Displays global status of IPv6 PIMSM and its
IPv6 routing interfaces.
PE
show ipv6 pimsm bsr Displays the bootstrap router (BSR)
information.
PE
show ipv6 pimsm interface Displays interface config parameters. PE
show ipv6 pimsm neighbor Displays IPv6 PIM neighbors learned on the
routing interfaces.
PE
show ipv6 pimsm rphash Displays which rendezvous point (RP) is being
selected for a specified group.
PE
show ipv6 pimsm rp
mapping
Displays all group-to-RP mappings of which the
router is aware (either configured or learned
from the bootstrap router (BSR).
PE
a. For the meaning of each Mode abbreviation, see Mode Types on page 79.
Command Description Mode
a
clear ipv6 neighbors Clears all entries in the IPv6 neighbor table
or an entry on a specific interface.
PE
Command Description Mode
a
2CSPC4.XModular-SWUM201.book Page 127 Monday, October 3, 2011 2:21 PM