Command Line Interface Guide

Command Groups 119
DHCP Server and Relay Agent (IPv4)
Command Description Mode
a
ip dhcp pool Defines a DHCP address pool that can be used
to supply addressing information to DHCP
client. This command puts the user into DHCP
Pool Configuration mode.
GC
bootfile Sets the name of the image for the DHCP
client to load.
DP
clear ip dhcp binding Removes automatic DHCP server bindings. PE
clear ip dhcp conflict Removes DHCP server address conflicts. PE
client-identifier Identifies a a Microsoft
®
DHCP client to be
manually assigned an address.
DP
client-name Specifies the host name of a DHCP client. DP
default-router Sets the IPv4 address of one or more routers for
the DHCP client to use.
DP
dns-server (IP DHCP Pool
Config)
Sets the IPv4 DNS server address which is
provided to a DHCP client by the DHCP server.
DP
domain-name (IP DHCP
Pool Config)
Sets the DNS domain name which is provided
to a DHCP client by the DHCP server.
DP
hardware-address Specifies the MAC address of a client to be
manually assigned an address.
DP
host Specifies a manual binding for a DHCP client
host.
DP
ip dhcp bootp automatic Enables automatic BOOTP address
assignments.
GC
ip dhcp conflict logging Enables DHCP address conflict detection. GC
ip dhcp excluded-address Excludes one or more DHCP addresses from
automatic assignment.
GC
ip dhcp ping packets Configures the number of pings sent to detect if
an address is in use prior to assigning an address
from the DHCP pool.
GC
lease Sets the period for which a dynamically
assigned DHCP address is valid.
DP
2CSPC4.XModular-SWUM201.book Page 119 Monday, October 3, 2011 2:21 PM