Command Line Interface Guide

IPv6 Multicast Commands 1157
Syntax
ipv6 pimsm spt-threshold threshold
no ipv6 pimsm spt-threshold
• threshold —The threshold rate (Range: 0–2000 Kbps).
Default Configuration
The default threshold rate is 0.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 pimsm spt-threshold 1000
ipv6 pimsm ssm
Use the ipv6 pimsm ssm command to define the Source Specific Multicast
(SSM) range of multicast addresses.
Syntax
ipv6 pimsm ssm { default | group-address/prefixlength }
• default—Defines the SSM range access list to 232/8.
• group-address—Group IP address supported by RP.
• prefixlength—This parameter specifies the prefix length of the IP address
for the media gateway. (Range: 1–32)
Default Configuration
There is no SSM range defined by default.
Command Mode
Global Configuration mode
2CSPC4.XModular-SWUM201.book Page 1157 Monday, October 3, 2011 2:21 PM