Reference Guide

IronWare Software Release 02.8.00a for Brocade BigIron RX Series Swtches
Release Notes v 1.0 Page 34 of 40
Defect ID: DEFECT000271931
Technical Severity: High
Summary: VRRP/STP flap when BGP session is reset (full Internet route table is withdrawn and updated)
Symptom: VRRP flap is seen.
Feature: L2 Protocol
Function: VSRP1
Probability: Medium
Found in Release: RX 02.4.00
Service Request ID: 178709
Defect ID: DEFECT000272067 Technical Severity: High
Summary: Need ability to resolve IPv6 addresses using IPv4 transport per the RFC 3596
Symptom: RX cannot resolve IPv6 addresses through IPv4 DNS queries
Feature: DNS Function: PROTOCOL
Probability: High
Found in Release: RX 02.7.00 Service Request ID: 215029
Defect ID: DEFECT000310529
Technical Severity: High
Summary: An Interface module may reload when a new L2 multicast stream is received.
Symptom: Interface module may reload.
Feature: IPv4 MC-Snooping (VLAN)
Function: IGMP Snooping
Probability: Low
Found in Release: RX 02.7.02
Service Request ID:
Defect ID: DEFECT000316902 Technical Severity: High
Summary: An LSA with a higher metric can prevent the route installation of an LSA which has a lower metric and
broadcast address LS ID.
Symptom: When a static route is added on one router, a route for the same network may disappear on another router.
Feature: OSPF
Function: Redistribution
Probability: High
Found in Release: RX 02.7.00 Service Request ID: 260272
Defect ID: DEFECT000323269
Technical Severity: High
Summary: Interface module may reload after ‘show ip cache’ command is executed.
Symptom: Interface module may reload after ‘show ip cache’ command is entered on an Interface module which had run
out of next-hop entries.
Feature: CLI Infrastructure Function: Parser Engine
Probability: Low
Found in Release: RX 02.7.02 Service Request ID: 265696
Defect ID: DEFECT000301863
Technical Severity: High
Summary: An OSPF route with metric of 65535 is not installed in the routing table.
Symptom: Using the configuration 'auto-cost reference-bandwidth 100000' will prevent routes from a GRE tunnel
interface from being installed.
Workaround: Remove the auto-cost reference-bandwidth 100000 or set the cost on the GRE tunnel interface.
Feature: OSPF
Function: PROTOCOL
Probability: High
Found in Release: RX 02.7.02 Service Request ID: 248796