Release Notes

IronWare Software Release 02.7.03a for Brocade BigIron RX Series Swtches
Release Notes v 1.0 Page 39 of 40
Defect ID:
DEFECT000305721
Technical Severity:
Medium
Summary:
OSPF interface cannot be established between a VE interface on 16x10G linecard. This was seen
when the 16x10G card is in an RX-4 system.
Symptom:
Unable to for a OSPF adjacency.
Probability:
High
Feature:
OSPF
Function:
PROTOCOL
Reported In Release:
RX 02.7.02
Service Request ID:
251533
Defect ID:
DEFECT000306096
Technical Severity:
High
Summary:
With Multicast enabled, traffic may stop forwarding due to buffer depletion.
Symptom:
Protocols went down due to buffer depletion.
Probability:
Low
Feature:
IPv4-MC PIM-SM Routing
Function:
SCALABILITY
Reported In Release:
RX 02.7.02
Service Request ID:
249142
Defect ID:
DEFECT000306310
Technical Severity:
Medium
Summary:
Console message "incomplete command" may be seen when configuring a remark parameter on
named access-lists.
Symptom:
An error message is seen when configuring a ACL.
Probability:
Low
Feature:
ACL
Function:
IPv4
Reported In Release:
RX 02.7.02
Service Request ID:
251509
Defect ID:
DEFECT000306574
Technical Severity:
Medium
Summary:
A static RP ACL fails to map if one of the RP ACLs is not defined.
Symptom:
ACL is not working correctly.
Probability:
Medium
Feature:
IPv4-MC PIM-SM Routing
Function:
Static RP
Reported In Release:
RX 02.7.02
Service Request ID:
255479
Defect ID:
DEFECT000308240
Technical Severity:
High
Summary:
An Interface module may reload if a trunk port with multicast boundary flaps.
Symptom:
Interface module reloads.
Probability:
Low
Feature:
IPv4-MC PIM-SM Routing
Function:
Multicast Boundary- TTL Threshold
Reported In Release:
RX 02.7.02
Service Request ID:
255504
Defect ID:
DEFECT000308974
Technical Severity:
Medium
Summary:
When a LAG is configured with a combination of 16x10G ports and 4x10G ports on the same chassis
some protocols fail.
Symptom:
LAG across ports from both 16x10 and 4x10 line cards may stop forwarding traffic after some time.
Workaround:
Don't assign non 16x10 ports to a 16x10 LAG.
Probability:
Low
Feature:
LAG
Function:
Static
Reported In Release:
RX 02.7.02
Service Request ID:
251681