Release Notes

IronWare Software Release 02.7.03a for Brocade BigIron RX Series Swtches
Release Notes v 1.0 Page 38 of 40
Defect ID:
DEFECT000301863
Technical Severity:
High
Summary:
An OSPF route with metric of 65535 is not installed in the routing table.
Symptom:
Using the configuration 'auto-cost reference-bandwidth 100000' will prevent routes from a GRE tunnel
interface from being installed.
Workaround:
Remove the auto-cost reference-bandwidth 100000 or set the cost on the GRE tunnel interface.
Probability:
High
Feature:
OSPF
Function:
PROTOCOL
Reported In Release:
RX 02.7.02
Service Request ID:
248796
Defect ID:
DEFECT000302010
Technical Severity:
Medium
Summary:
Inserted "0" to ipv6 prefix-list for fe80::/
Symptom:
When IPv6 prefix list was created, only fe80::/ prefix list automatically inserted “0” to running-config.
Probability:
High
Feature:
IPV6
Function:
Prefix-list
Reported In Release:
RX 02.7.02
Service Request ID:
246057
Defect ID:
DEFECT000302184
Technical Severity:
Medium
Summary:
System reloads due to an incorrect Management module sync message
Probability:
Low
Feature:
SYSTEM
Function:
Event Manager
Reported In Release:
RX 02.6.00
Service Request ID:
251711
Defect ID:
DEFECT000302396
Technical Severity:
Medium
Summary:
The RADIUS configuration is missing the auth-port keyword for ipv6 which can result in the
command not getting parsed correctly on reload.
Symptom:
The RADIUS configuration is missing the auth-port keyword for IPv6 which can result in the
command not getting parsed correctly on reload.
telnet@XMR13(config)#radius-server host ipv6 fe80::2 ?
DECIMAL Number
Workaround:
Need to re-enter radius-server CLI command every time after reload.
Probability:
High
Feature:
AAA
Function:
RADIUS Authentication
Reported In Release:
RX 02.7.02
Service Request ID:
247801
Defect ID:
DEFECT000303316
Technical Severity:
Medium
Summary:
The router may reload when issuing the "show media" command.
Symptom:
Reload
Probability:
Medium
Feature:
SYSTEM
Function:
I2C
Reported In Release:
RX 02.7.02
Service Request ID:
251305
Defect ID:
DEFECT000303782
Technical Severity:
High
Summary:
High CPU may occur when IGMP & PIM is configured.
Symptom:
Running PIM on multiple VLANs that have a large numbers of ports, the following message may be
seen below every igmp query interval.
"[mcast] ip_tx's Q is Full - max 65536, 65536, current 65512, 0"
Probability:
Medium
Feature:
IPv4-MC IGMP
Function:
SCALABILITY
Reported In Release:
RX 02.7.02
Service Request ID:
249377