Release Notes

IronWare Software Release 02.7.03a for Brocade BigIron RX Series Swtches
Release Notes v 1.0 Page 37 of 40
Defect ID:
DEFECT000290430
Technical Severity:
Medium
Summary:
When a port is removed from a LAG it gets stuck in blocking state.
Symptom:
If an up interface is added to a LAG, but the LAG is not deployed and then the interface is removed
from the LAG. The interface could be left in blocking state.
Probability:
Low
Feature:
LAG
Function:
LACP
Reported In Release:
RX 02.7.02
Service Request ID:
238882
Defect ID:
DEFECT000290641
Technical Severity:
High
Summary:
ARP sync may fail during high rate of IPC traffic
Symptom:
ARP entries may in certain situations be higher on Linecard resulting in "out of sync' condition and
'blackhole' of traffic.
Workaround:
Hosts can be pinged from MP in order to trigger arp sync of entry
Probability:
Medium
Feature:
IPv4 Forwarding
Function:
ARP
Reported In Release:
RX 02.7.02
Defect ID:
DEFECT000298275
Technical Severity:
High
Summary:
Interface module reloads when add/remove interface rate-limit command
Symptom:
Interface module reloads.
Probability:
Medium
Feature:
ACL
Function:
IPv4
Reported In Release:
RX 02.4.00
Service Request ID:
246870
Defect ID:
DEFECT000299727
Technical Severity:
Medium
Summary:
Show redundancy endtime display may be corrupted
Symptom:
Show redundancy endtime display corrupted
Probability:
Low
Feature:
SYSTEM
Function:
Hitless failover
Reported In Release:
RX 02.7.02
Service Request ID:
249289
Defect ID:
DEFECT000299851
Technical Severity:
High
Summary:
Create new VLAN command gets insufficient FIDs for VLAN creation error
Symptom:
Multicast MAC entries don’t age in hardware and over time FIDs resource is exhausted. When
configuring new VLAN, the following error occurs
RX(config)#vlan 3100 n
error - insufficient fids available for vlan creation
Workaround:
If the user executes "clear ip multicast all" the FIDs will be reclaimed.
Probability:
Low
Feature:
IPv4 MC-Snooping (VLAN)
Function:
IGMP Snooping
Reported In Release:
RX 02.7.02
Service Request ID:
247249
Defect ID:
DEFECT000300236
Technical Severity:
Medium
Summary:
RX only sends SNMPv1 traps, and there is no way to generate traps in SNMPv2 or v3.
Symptom:
Unable to generate traps in SNMPv2 or v3.
Probability:
Medium
Feature:
SNMP Management
Function:
Trap/Notification
Reported In Release:
RX 02.7.02
Service Request ID:
249438