Release Notes

IronWare Software Release 02.7.03a for Brocade BigIron RX Series Swtches
Release Notes v 1.0 Page 30 of 40
Defects
NOTE: In the tables below, "Reported In Release" indicates the product and release that the defect was
first identified. If the problem also appeared in other Brocade IP Products, the issue was addressed using
the same defect ID.
Closed defects with code change in Multi-Service IronWare
R02.7.03a.
Defect ID:
DEFECT000316902
Technical Severity:
High
Summary:
An LSA with a higher metric can prevent the route installation of an LSA which has a lower metric
and broadcast address LS ID.
Symptom:
When a static route is added on one router, a route for the same network may disappear on another
router.
Probability:
High
Feature:
OSPF
Function:
Redistribution
Reported In Release:
RX 02.7.00
Service Request ID:
260272
Defect ID:
DEFECT000317027
Technical Severity:
Medium
Summary:
Router sends duplicate multicast packets when IGMP Snooping and Sflow are enabled.
Probability:
Medium
Feature:
IPv4-MC IGMP
Function:
IGMPv1/v2 Protocol
Reported In Release:
RX 02.7.02
Service Request ID:
259119
Defect ID:
DEFECT000318055
Technical Severity:
Medium
Summary:
Removed ability to set temperature polling interval to zero using CLI.
Probability:
High
Feature:
SYSTEM
Function:
Temp sensor & Monitoring
Reported In Release:
RX 02.7.02
Service Request ID:
256590
Defect ID:
DEFECT000318432
Technical Severity:
Medium
Summary:
If "clock summer-time" is configured, then system reloads one hour later than the configured reload
time using "reload at" command.
Symptom:
After configuring "clock summer-time" the system reloads one hour later than the configured reload
time when using the "reload at" command.
Probability:
Low
Feature:
SYSTEM
Function:
TIMER
Reported In Release:
RX 02.7.02
Service Request ID:
262013
Defect ID:
DEFECT000321237
Technical Severity:
Medium
Summary:
When a stub area is configured the ‘show ip ospf border-router’ command incorrectly displays the area
value.
Probability:
Medium
Feature:
OSPF
Function:
show commands
Reported In Release:
RX 02.7.02
Service Request ID:
262838