Release Notes

Closed defects with code change in Fabric OS v7.2.0
Fabric OS v7.2.0a Release Notes v1.0 Page 67 of 93
Defect ID:
DEFECT000432816
Technical Severity:
Medium
Summary:
Logical port pid is manipulation when domain ID changes.
Symptom:
Port identifier of LISL port was not assigned correctly after setting LISL.
Risk of Fix:
Medium
Probability:
High
Feature:
FOS Software
Function:
Virtual Fabric
Reported In Release:
FOS6.3.2
Service Request ID:
1031600
Defect ID:
DEFECT000433313
Technical Severity:
Medium
Summary:
CP Faulty reason is not persistent over a reboort
Symptom:
CP which is indicating "Faulty(53) - Possible RRD" does not persist the failing reason over a reboot
Risk of Fix:
Low
Probability:
Low
Feature:
System Controls/EM
Function:
Infrastructure
Reported In Release:
FOS7.1.0
Defect ID:
DEFECT000433466
Technical Severity:
High
Summary:
ICL vs ISL selection when both are available needs to be consistent
Symptom:
When a customer has both 16G ICL and ISL paths leaving the current switch that can all be used for
routing to a remote domain (even if the domain is multiple hops away), when in port based mode, the
devices and ingress routes on that switch are all routed to the ISL instead of using any of the ICLs.
Workaround:
Make sure that there are only ICL or ISL based egress paths to use when routing traffic to any
given destination domain. Even if the destination is multiple hops away.
Risk of Fix:
Low
Probability:
Medium
Feature:
16G Platform Services
Function:
Routing
Reported In Release:
FOS7.1.0
Service Request ID:
,1171733
Defect ID:
DEFECT000433562
Technical Severity:
Medium
Summary:
For all 16G platforms and FC8-32E/FC8-48E blades, error message is shown when Web Tools port
admin wizard is used to configure long distance with VC_Link INIT set to Arbitrary(1)
Symptom:
An error message is displayed when trying to configure long distance in the Web Tools port
configuration wizard "Valid configurations are :vc_translation_link_init=0, fillword = IDLE_IDLE or
vc_translation_link_init=1, fillword = ARB_ARB,IDLE_ARB,AA_THEN_IA"
Risk of Fix:
Low
Probability:
Medium
Feature:
WebMgmt
Function:
Ports Admin
Reported In Release:
FOS7.1.0
Defect ID:
DEFECT000433644
Technical Severity:
High
Summary:
DCX8510-8 in reboot loop with POST failing for all 16G blades where the default FID of the default
switch was changed to something other than 128
Symptom:
After a physical power failure, DCX8510-8 went into a reboot loop with all 16G port baldes failing
POST.
Risk of Fix:
Low
Probability:
Medium
Feature:
Diagnostics
Function:
Post Diags
Reported In Release:
FOS7.1.0
Defect ID:
DEFECT000433727
Technical Severity:
High
Summary:
Logical Fabric Addressing Modes unexpectedly modified
Symptom:
Cannot go back to Logical Fabric Addressing Mode 0, after configuring for mode 1 or 2.
Risk of Fix:
Low
Probability:
Medium
Feature:
16G Platform Services
Function:
Partition Management
Reported In Release:
FOS7.1.0