Release Notes

Open Defects in Fabric OS v7.2.0
Fabric OS v7.2.0a Release Notes v1.0 Page 48 of 93
Defect ID:
DEFECT000433534
Technical Severity:
Medium
Summary:
[H1520]FW-1403 event after Flash value crosses low threshold from below to inbetween.
Symptom:
FW-1403 generated when Flash value crosses its low threshold from below to inbetween during low
threshold testing and high threshold is tested previously
Feature:
FABRIC WATCH
Function:
Other
Service Request ID:
1118425,743111
Reported In Release:
FOS7.0.2
Probability:
Medium
Defect ID:
DEFECT000435100
Technical Severity:
Medium
Summary:
SNMPCONFIG is inconsistent on ISCSI settings
Symptom:
Disable ISCSI-mibcapability in FOSv6.3 and then upgraded to FOSv6.4, when the new firmware
comes up, ISCSI- MIB is in disabled state and ISCSI-TRAPS are in enabled state.
Feature:
FOS Software
Function:
SNMP
Service Request ID:
1124455
Reported In Release:
FOS6.3.0
Probability:
Medium
Defect ID:
DEFECT000437932
Technical Severity:
Medium
Summary:
QoS Failure events when deleting logical switche
Symptom:
Logical switch delete failed follow by QoS errors and numerous supportsave errors during data collect
Feature:
FC Services
Function:
QOS
Reported In Release:
FOS7.1.0
Probability:
Low
Defect ID:
DEFECT000443325
Technical Severity:
Medium
Summary:
Unable to set default values for the first time in Extended Fabrics tab.
Symptom:
User will not be able to set back to default values on the first try.
Workaround:
Issue the command again.
Feature:
WebMgmt
Function:
Switch Admin
Reported In Release:
FOS7.1.0
Probability:
Medium
Defect ID:
DEFECT000445731
Technical Severity:
Medium
Summary:
After FX8-24 Blade FCIP Tunnel failure and recovery, IO did not resume due to stuck VC
Symptom:
IO traffic could not be restarted after FCIP Tunnel recovered from keepalive Timeout
Workaround:
Powercycle the core blade(s)
Feature:
8G ASIC Driver
Function:
C2 ASIC driver
Service Request ID:
1147110
Reported In Release:
FOS7.0.2
Probability:
Low
Defect ID:
DEFECT000447147
Technical Severity:
Medium
Summary:
D-Port test results incorrectly shows manual mode from the Access Gateway then HBA configured
for D-Port was rebooted
Symptom:
Access Gateway D-Port test results incorrectly shows manual mode when the HBA configured for D-
Port was rebooted. Results should display automatic mode.
Feature:
Fabric Services
Function:
D-port
Reported In Release:
FOS7.2.0
Probability:
Medium
Defect ID:
DEFECT000448581
Technical Severity:
Medium
Summary:
Port Rename, F-Port BB Credit & NPIV Max Login dialogs still persist even after the connection is
timed out and allows user to configure the values.
Symptom:
User is erroneously allowed to configure the values even after the connection times out.
Feature:
WebMgmt
Function:
Ports Admin
Reported In Release:
FOS7.2.0
Probability:
Medium