Reference Guide

FIP Snooping Commands 907
User Guidelines
It is recommended that FCF-facing ports be placed into auto-upstream mode
in order to receive DCBX information and propagate it to the CNAs on the
downstream (host-facing) ports.
Interfaces enabled for PFC should be configured in trunk or general mode
and must be PFC-operationally enabled before FCoE traffic can pass over the
port.
This command can only be entered after FIP snooping is enabled using the
feature fip-snooping command. Otherwise, it does not appear in the CLI
syntax tree.
Example
The following example configures an interface to be connected to an FCF
switch.
(config)# interface te1/0/1
(config-vlan)# fip-snooping port-mode fcf
show fip-snooping
Use the show fip-snooping sessions command in User EXEC or Privileged
EXEC mode to display information about the global FIP snooping
configuration and status.
Syntax
show fip-snooping
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC, Config mode and all Config sub-modes
User Guidelines
The following information is displayed.
2CSPC4.X8100-SWUM102.book Page 907 Friday, March 15, 2013 8:56 AM