Reference Guide

VLAN Commands 819
User Guidelines
The dynamic VLAN (created via GRVP) should exist prior to executing this
command. See the Type column in output from the
show vlan command to
determine that the VLAN is dynamic.
Example
The following changes vlan 3 to a static VLAN.
console(config-vlan)#vlan makestatic 3
vlan protocol group
Use the vlan protocol group command in Global Configuration mode to add
protocol-based groups to the system. When a protocol group is created, it is
assigned a unique group ID number. The group ID is used to identify the
group in subsequent commands. Use the no form of the command to remove
the specified VLAN protocol group name from the system.
Syntax
vlan protocol group groupid
no vlan protocol group groupid
• groupid — The protocol-based VLAN group ID, to create a protocol-based
VLAN group. To see the created protocol groups, use the
show port
protocol al
l command.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
console(config)# vlan protocol group 1
2CSPC4.X8100-SWUM102.book Page 819 Friday, March 15, 2013 8:56 AM