Reference Guide

Port Channel Commands 615
Manual Aggregation of LAGs
PowerConnect switching supports the manual addition and deletion of links
to aggregates.
Flexible Assignment of Ports to LAGs
Assignment of interfaces to dynamic LAGs is based upon a maximum of 144
interfaces assigned to dynamic LAGs, a maximum of 128 dynamic LAGs and
a maximum of 8 interfaces per dynamic LAG. For example, 128 LAGs may be
assigned 2 interfaces each or 18 LAGs may be assigned 8 interfaces each.
Commands in this Chapter
This chapter explains the following commands:
channel-group
Use the channel-group command in Interface Configuration mode to
associate a port with a port channel. To remove the channel-group
configuration from the interface, use the no form of this command.
Syntax
channel-group port-channel-number mode {on | active}
no channel-group
• port-channel-number — Number of a valid port-channel with which to
associate the current interface.
•
on — Forces the port to join a channel without LACP (static LAG).
channel-group lacp timeout
interface port-channel port-channel local-preference
interface range port-channel port-channel min-links
hashing-mode show interfaces port-channel
lacp port-priority show lacp
lacp system-priority show statistics port-channel
2CSPC4.X8100-SWUM102.book Page 615 Friday, March 15, 2013 8:56 AM