Reference Guide

Address Table Commands 317
show ports security addresses
Use the show ports security addresses command in Privileged EXEC mode to
display current dynamic addresses in locked ports.
Syntax
show ports security addresses {gigabitethernet unit/slot/port | port-channel
port-channel-number | tengigabitethernet unit/slot/port |
fortygigabitethernet
unit/slot/port }
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Examples
The following example displays dynamic addresses for port channel number
1/0/1.
console#show ports security addresses Te1/0/1
Dynamic addresses: 83
Maximum The maximum addresses that can be associated
on this port in Static Learning mode or in
Dynamic Learning mode.
Trap Indicates if traps would be sent in case of
violation.
Frequency The minimum time between consecutive traps.
Field Description
2CSPC4.X8100-SWUM102.book Page 317 Friday, March 15, 2013 8:56 AM