Reference Guide

System Management Commands 1745
Default Configuration
The default count is 3 probes.
The default interval is 3 seconds.
The default size is 0 data bytes.
The default port is 33434.
The default initTtl is 1 hop.
The default maxTtl is 30 hops.
The default maxFail is 5 probes.
Command Mode
Privileged EXEC mode.
User Guidelines
There are no user guidelines for this command.
Examples
The following example discovers the routes that packets will actually take
when traveling to the destination specified in the command.
console#traceroute 192.168.77.171
count The number of probes to be sent at each TTL level
(Range:1–10).
port The destination UDP port of the probe. This should be an
unused port on the remote destination system (Range:
1–65535).
size The size, in bytes, of the payload of the Echo Requests sent
(Range: 0–65507 bytes).
src-ip-address The IPv4 source address to use in the ICMP echo request
packets.
vlan A valid VLAN interface.
loop-id A configured loopback ID
Parameter Description
2CSPC4.X8100-SWUM102.book Page 1745 Friday, March 15, 2013 8:56 AM