Reference Guide

1626 SNMP Commands
bad packet.......................Enabled
config error.....................Enabled
virt authentication failure .....Disabled
virt bad packet..................Disabled
virt config error................Disabled
if-rx: if-rxpacket...............Disabled
lsa: lsamaxage...................Disabled
lsaoriginate.....................Disabled
overflow: lsdboverflow...........Enabled
lsdb-approaching-overflow........Enabled
retransmit:
packets..........................Disabled
virtpackets......................Disabled
rtb: rtb-entryinfo...............Disabled
state-change:
all..............................Disabled
if state change..................Enabled
neighbor state change............Enabled
virtif state change..............Disabled
virtneighbor state change........Disabled
snmp-server community
Use the snmp-server community command in Global Configuration mode to
set up the community access string to permit access to the SNMP protocol.
To remove the specified community string, use the no form of this command.
Syntax
snmp-server community string {ro | rw | su} [view view-name ][ipaddress
ipaddress ]
no snmp-server community
string
2CSPC4.X8100-SWUM102.book Page 1626 Friday, March 15, 2013 8:56 AM