Reference Guide

1344 OSPFv3 Commands
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Example
The following example displays the OSPF Virtual Interface information for
area 1 and its neighbor.
console#show ipv6 ospf virtual-link 1 1.1.1.1
Area ID........................................ 1
Neighbor Router ID............................. 1.1.1.1
Hello Interval................................. 10
Dead Interval.................................. 40
Iftransit Delay Interval....................... 1
Retransmit Interval............................ 5
State.......................................... point-to-
point
Metric......................................... 10
Neighbor State................................. Full
show ipv6 ospf virtual-link brief
Use the show ipv6 ospf virtual-link brief command in Privileged EXEC mode
to display the OSPFV3 Virtual Interface information for all areas in the
system.
Syntax
show ipv6 ospf virtual-link brief
2CSPC4.X8100-SWUM102.book Page 1344 Friday, March 15, 2013 8:56 AM