Reference Guide

1324 OSPFv3 Commands
Example
The following example sets a 4-digit dotted-decimal number identifying the
Router OSPF ID as 2.3.4.5.
console(config)#ipv6 router ospf
console(config-rtr)#router-id 2.3.4.5
show ipv6 ospf
Use the show ipv6 ospf command in Privileged EXEC mode to display
information relevant to the OSPF router.
Syntax
show ipv6 ospf [ area-id ]
area-id — Identifier for the OSPF area being displayed.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
Some of the information below displays only if you enable OSPF and
configure certain features. The following fields may be displayed:
Field Description
Router ID A 32-bit integer in dotted decimal format identifying the router
about which information is displayed. This is a configured value.
OSPF Admin
Mode
Shows whether OSPF is administratively enabled or disabled.
External LSDB
Limit
Shows the maximum number of non-default external LSAs
entries that can be stored in the link-state database.
2CSPC4.X8100-SWUM102.book Page 1324 Friday, March 15, 2013 8:56 AM