Setup Guide
Table Of Contents
- Dell PowerConnect 7000 Series Switch
- Getting Started Guide
- 使用入门指南
- 入門指南
- Guide de mise en route
- Table des matières
- Introduction
- Présentation générale des commutateurs PowerConnect de la série 7000
- Présentation du matériel
- Installation
- Démarrage et configuration du commutateur
- Budget de puissance PoE
- Reihe PowerConnect 7000 - Übersicht
- Handbuch zum Einstieg
- Panduan Pengaktifan
- はじめに
- 시작 안내서
- Guía de introducción
- Contenido
- Introducción
- Información general sobre el hardware
- Instalación
- Inicio y configuración del conmutador
- Consumo previsto de PoE
- Başlangıç Kılavuzu
- Getting Started Guide (Hebrew)
- Guia de Primeiros Passos
16 Getting Started Guide
Figure 1-11. Attaching the Brackets
2
Insert the supplied bolts into the rack-mounting holes and tighten with a
screwdriver.
3
Repeat the process for the rack-mounting bracket on the other side of the
switch.
4
Insert the switch into the 48.26 cm (19 inch) rack, ensuring that the rack-
mounting holes on the switch line up to the mounting holes in the rack.
5
Secure the switch to the rack with either the rack bolts or cage nuts and
cage-nut bolts with washers (depending on the kind of rack you have).
Fasten the bolts on bottom before fastening the bolts on top.
CAUTION: Make sure that the supplied rack bolts fit the pre-threaded holes in the
rack.
NOTE: Make sure that the ventilation holes are not obstructed.