Reference Guide

546 GVRP Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\GVRP.fm
DELL CONFIDENTIAL – PRELIMINARY 10/21/13 - FOR PROOF ONLY
Syntax
gvrp enable
no gvrp enable
Default Configuration
GVRP is disabled on all interfaces.
Command Mode
Interface Configuration (Ethernet, Port-channel) mode
User Guidelines
GVRP is only operational if it is enabled on a general mode port.
Example
The following example enables GVRP on gigabitethernet port 1/0/6.
Console(config)# interfa ce gi1/0/ 6
Console(config-if)# gvrp enable
garp timer
Use the garp timer Interface Configuration (Ethernet, port channel) mode
command to adjust the values of the join, leave and leaveall timers of GARP
applications, such as GVRP. Use the no form of this command to restore the
default configuration.
Syntax
garp timer {join | leave | leaveall} timer-value
no garp timer
Parameters
• join | leave | leaveall —Specifies the type of timer for which the timer
value is specified. The possible values are:
• join—Specifies the GARP join timer. The GARP join timer value
specifies the time interval between the two join messages sent by the
GARP application.