Reference Guide

Address Table Commands 387
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\Address_Table.fm
DELL CONFIDENTIAL – PRELIMINARY 10/21/13 - FOR PROOF ONLY
You can execute the command before the VLAN is created.
Example
The following example registers the MAC address to the bridge table:
Console(config)# interface vlan 8
Console(config-if)#
bridge multicast address 01:00:5e:02:02:03
The following example registers the MAC address and adds ports statically.
Console(config)# interface vlan 8
Console(config-if)#
bridge multicast address 01:00:5e:02:02:03
add gi1/0/1-2
bridge multicast forbidden address
Use the bridge multicast forbidden address Interface Configuration (VLAN)
mode command to forbid adding or removing a specific multicast address to
or from specific ports. Use the no form of this command to restore the default
configuration.
Syntax
bridge multicast forbidden address { mac-multicast-address } {add | remove}
{ethernet
interface-list | port-channel port-channel-list }
no bridge multicast forbidden address {
mac-multicast-address }
Parameters
• mac-multicast-address —Specifies the group MAC multicast address.
•
add —Forbids adding ports to the group.
•
remove —Forbids removing ports from the group.
•
ethernet interface-list —Specifies a list of Ethernet ports. Separate
nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen
to designate a range of ports.