Reference Guide

362 Power over Ethernet (PoE) Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\PoE.fm
DELL CONFIDENTIAL – PRELIMINARY 10/21/13 - FOR PROOF ONLY
Short Counter: 0
Denied Counter: 0
Absent Counter: 0
Invalid Signature Counter: 0
The following table describes the fields shown in the display:
Field Description
Power The inline power sourcing equipment operational status.
Nominal Power The inline power sourcing equipment nominal power in
Watts.
Consumed Power The measured usage power in Watts.
Usage Threshold The usage threshold expressed in percent for comparing
the measured power and initiating an alarm if threshold is
exceeded.
Traps Indicates if inline power traps are enabled.
Port The Ethernet port number.
Powered device A description of the powered device type.
Admin State Indicates if the port is enabled to provide power. The
possible values are Auto or Never.
Priority The port inline power management priority. The possible
values are Critical, High or Low.
Oper State Describes the port inline power operational state. The
possible values are On, Off, Test-Fail, Testing, Searching or
Fault.
Classification The power consumption classification of the powered
device.
Overload Counter Counts the number of overload conditions detected.
Short Counter Counts the number of short conditions detected.
Denied Counter Counts the number of times power was denied.
Absent Counter Counts the number of times power was removed because
powered device dropout was detected.
Invalid Signature
Counter
Counts the number of times an invalid signature of a
powered device was detected.