Reference Guide

360 Power over Ethernet (PoE) Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\PoE.fm
DELL CONFIDENTIAL – PRELIMINARY 10/21/13 - FOR PROOF ONLY
Default Configuration
The default value is the maximum power allowed in the specific working
mode:
• 15.4W
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example sets inline power on a port.
console(config)# interface gi1/0/1
console(config-if)# power inline limit 2222
show power inline
Use the show power inline EXEC mode command to display information
about the inline power for all interfaces or for a specific interface.
Syntax
show power inline [ interface-id | module stack-member-number ]
Parameters
• interface-id —Specifies an interface ID. The interface ID must be an
Ethernet port.
•
stack-member-number —Specifies the switch member in a stack.
Default Configuration
There is no default configuration for this command.
Command Mode
EXEC mode