Reference Guide

Power over Ethernet (PoE) Commands 357
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\PoE.fm
DELL CONFIDENTIAL – PRELIMINARY 10/21/13 - FOR PROOF ONLY
Parameters
pd-type—Enters a comment or a description to assist in recognizing the type
of the powered device attached to this interface. (Length: 1–24 characters)
Default Configuration
There is no description.
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example adds the description ‘ip phone’ of the device
connected to port 4.
Console(config)# interface gi1/0/ 4
Console(config-if)# power inline powered-device ip phone
power inline priority
Use the power inline priority Interface Configuration (Ethernet) mode
command to configure the interface inline power management priority. Use
the no form of this command to restore the default configuration.
Syntax
power inline priority {critical | high | low}
no power inline priority
Parameters
• critical —Specifies that the powered device operation is critical.
•
high —Specifies that the powered device operation is high priority.
•
low —Specifies that the powered device operation is low priority.
Default Configuration
The default configuration is set to low priority.