Reference Guide

Ethernet Configuration Commands 347
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\Ethernet.fm
DELL CONFIDENTIAL – PRELIMINARY 10/21/13 - FOR PROOF ONLY
show storm-control
Use the show storm-control EXEC mode command to display the
configuration of storm control.
Syntax
show storm-control [ interface-id | detailed]
Parameters
• interface-id —Specifies the interface.
•
detailed —Displays information for non-present ports in addition to
present ports.
Default Configuration
Display is for present ports.
Command Mode
EXEC mode
Example
console# show storm-control
Port State Rate [Kbits/Sec] Included
------ -------- --------------- ------------------------
gi1/0/ 1 Enabled 12345 Broadcast, Multicast,
Unknown unicast
gi1/0/ 2 Disabled 100000 Broadcast
User Guidelines
Use the storm-control broadcast enable Interface Configuration command to
enable storm control.
The calculated rate includes the 20 bytes of Ethernet framing overhead
(preamble+SFD+IPG).
If the suppression level in percentage is translated (for the current port’s
speed) to a rate that is lower then the minimum rate, the minimum rate
would be set.