Reference Guide

168 SNMP Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\SNMP.fm
DELL CONFIDENTIAL – PRELIMINARY 10/21/13 - FOR PROOF ONLY
User Guidelines
The logical key of the command is the pair (ip-address/hostname,
traps/informs, version).
When configuring snmp v1 or v2 notifications recipient the software would
automatically generate a notification view for that recipient for all the MIB.
(.For SNMPv3 the software doesn’t automatically create a user nor a notify
view. Use the commands snmp-server user, snmp-server group and snmp-
server view in Global Configuration mode to create a user, a group or a notify
group respectively.
The format of an IPv6Z address is: <
ipv6-link-local-address>%<interface-
name
>
interface-name =
vlan<integer> | ch<integer> | isatap<integer> |
<physical-port-name> | 0
integer = < decimal-number> | <integer><decimal-number >
decimal-number = 0 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9
physical-port-name = Designated port number, for example 1/0/16
If the egress interface is not specified, the default interface is selected.
Specifying interface zone=0 is equal to not defining an egress interface.
Example
The following defines a host at the IP address displayed.
console(config)# snmp-server host 1.1.1.121 abc
snmp-server engineID local
The snmp-server engineID local Global Configuration mode command
specifies the Simple Network Management Protocol (SNMP) engineID on
the local device. Use the no form of this command to remove the configured
engine ID.
Syntax
snmp-server engineID local { engineid-string | default }
no snmp-server engineID local