Reference Guide

SNMP Commands 167
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\SNMP.fm
DELL CONFIDENTIAL – PRELIMINARY 10/21/13 - FOR PROOF ONLY
• ipv6-address —Pv6 address of the host (the targeted recipient). When the
IPv6 address is a Link Local address (IPv6Z address), the outgoing
interface name must be specified. Refer to the User Guidelines for the
interface name syntax.
•
hostname —Hostname of the host. (Range: 1–158 characters. Maximum
label size: 63)
•
trap —Sends SNMP traps to this host (default).
•
informs —Sends SNMP informs to this host. Not applicable to SNMPv1.
•
1 —SNMPv1 traps are used.
•
2c —SNMPv2 traps are used
•
3 —SNMPv2 traps are used
•
community-string —Password-like community string sent with the
notification operation. (Range: 1–20 characters)
•
noauth —Specifies no authentication of a packet.
•
auth —Specifies authentication of a packet without encrypting it.
•
priv —Specifies authentication of a packet with encryption.
•
udp-port port —UDP port of the host to use. The default is 162. (Range:
1–65535)
•
filter filtername —A string that is the name of the filter that defines the
filter for this host. If unspecified, nothing is filtered. The filter should be
defined using the command
snmp-server filter (no specific order of the
command configurations is imposed on the user). (Range: Up to 30
characters)
•
timeout seconds —Number of seconds to wait for an acknowledgment
before resending informs. The default is 15 seconds. The parameter is
relevant only for informs. (Range: 1–300)
•
retries retries —Maximum number of times to resend an inform request,
when a response is not received for a generated message. The default is 3.
The parameter is relevant only for informs. (Range: 0–255)
Command Mode
Global Configuration mode