User guide

90 Configuring System Information
Deleting the SNTP Server
1 Open the SNTP Servers page.
2 Click Show All.
The SNTP Servers Table opens.
3 Select an SNTP Server entry.
4 Select the Remove check box.
5 Click Apply Changes .
The entry is removed, and the device is updated.
Defining SNTP Servers Settings Using CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the SNTP
Servers page.
The following is an example of the CLI commands:
Table 6-9. SNTP Server CLI Commands
CLI Command Description
sntp server ipv4-address|ipv6-address|hostname
[poll] [key keyid]
Configures the device to use SNTP to request and
accept NTP traffic from as server.
console> enable
console# configure
Console(config)# sntp server 100.1.1.1 poll key 10
Console# show sntp status
Clock is synchronized, stratum 4, reference is 176.1.1.8
Reference time is AFE2525E.70597B34 (00:10:22.438 PDT Jul 5 1993)
Unicast servers:
Server Preference Status Last response Offset
[mSec]
Delay
[mSec]
--------- ---------- -------- --------------- ------ ------
176.1.1.8 Primary Up AFE252C1.6DBDDFF2 7.33 117.79
176.1.8.179 Secondary Unknown AFE21789.643287C9 8.98 189.19
Anycast server: