User guide

Configuring System Information 89
The following table summarizes the equivalent CLI commands for setting fields displayed in the Add
SNTP Server page.
Table 6-8. SNTP Server CLI Commands
The following is an example of the CLI commands:
Displaying the SNTP Server Table
1
Open the SNTP Servers page.
2 Click Show All.
The SNTP Servers Table opens:
Figure 6-13. SNTP Servers Table
Modifying an SNTP Server
1 Open the SNTP Servers page.
2 Click Show All.
The SNTP Servers Table opens.
3 Select an SNTP Server entry.
4 Modify the relevant fields.
5 Click Apply Changes .
The SNTP Server information is updated.
CLI Command Description
sntp server {ipv4-address|ipv6-
address|hostname [poll] [key keyid]
Configures the device to use SNTP to request and accept NTP
traffic from a server.
console> enable
console# configure
Console(config)# sntp server 100.1.1.1 poll key 10