User guide

Starting and Configuring the Device 53

UART Channel Loopback Test........................PASS

Testing the System SDRAM..........................PASS

Boot1 Checksum Test...............................PASS

Boot2 Checksum Test...............................PASS

Flash Image Validation Test.......................PASS

BOOT Software Version 1.0.0.20 Built 22-Jan-xxxx 15:09:28

Processor: FireFox 88E6218 ARM946E-S , 64 MByte SDRAM.

I-Cache 8 KB. D-Cache 8 KB. Cache Enabled.

Autoboot in 2 seconds - press RETURN or Esc. to abort and enter prom.

Preparing to decompress...

When the auto-boot message appears, press <Enter> to get the Startup menu. The Startup menu

procedures can be done using the ASCII terminal or Windows HyperTerminal.

[1] Download Software

[2] Erase Flash File

[3] Password Recovery Procedure

[4] Enter Diagnostic Mode

[5] Set Terminal Baud-Rate

[6] Back

Enter your choice or press 'ESC' to exit

The following sections describe the available Startup menu options.

NOTE: When selecting an option form the Startup menu, time out must be taken into account: if no selection is

made within 35 seconds (default), the device times out. This default value can be changed through CLI.