User guide

Configuring Device Information 281
Displaying the Port Configuration Table:
1 Open the Port Configuration page.
2 Click Show All.
The Ports Configuration Table opens:
Figure 7-23. Ports Configuration Table
Configuring Ports with CLI Commands
The following table summarizes the equivalent CLI commands for configuring ports as displayed in the
Ports Configuration Table page.
Table 7-12. Port Configuration CLI Commands
CLI Command Description
interface ethernet interface Enters the interface configuration mode to
configure an ethernet type interface.
description string Adds a description to an interface configuration.
shutdown Disables interfaces that are part of the currently set
context.
set interface active {ethernet
interface | port-channel port-channel-
number}
Reactivates an interface that is shutdown due to
security reasons.
speed bps Configures the speed of a given ethernet interface
when not using auto negotiation.
autobaud Sets the line for automatic baud rate detection.
duplex {half | full} Configures the full/half duplex operation of a given
ethernet interface when not using auto negotiation.
negotiation Enables auto negotiation operation for the speed
and duplex parameters of a given interface.
back-pressure Enables Back Pressure on a given interface.
flowcontrol {auto | on | off | rx | tx} Configures the Flow Control on a given interface.