User guide

Configuring System Information 225
• Link Local Interface — When the server supports an IPv6 Link Local address (see previous
parameter), this specifies the the Link Local interface. The possible values are:
–
VLAN1 — The IPv6 interface is configured on VLAN1.
–
ISATAP — The IPv6 interface is configured on ISATAP tunnel.
•
Firmware Upload — Indicates that the upload is for firmware. If Firmware Upload is selected,
the
Configuration Upload fields are grayed out.
•
Configuration Upload — Indicates that the upload is for configuration files. If Configuration Upload
is selected, the Firmware Upload fields are grayed out.
•
Upload via TFTP — Enables initiating an image upload via the TFTP server.
•
Upload via HTTP — Enables initiating an image upload via the FTP server.
Software Image Upload
• TFTP Server IP Address — The TFTP Server IP Address to which the Image file is uploaded.
•
Destination File Name (1-64 Characters) — Indicates the Image file path to which the file is
uploaded.
Configuration Upload
• TFTP Server IP Address — The TFTP Server IP Address to which the Configuration file is uploaded.
•
Destination File Name (1-64 Characters) — Indicates the Configuration file path to which the file is
uploaded.
•
Transfer File Name — The software file to which the configuration is uploaded. This list of
user-defined configuration files only appears if the user created backup configuration files.
For example, if the user copied the running configuration file to a user-defined configuration file
called BACKUP-SITE-1, this list appears on the File Upload to Server page and the BACKUP-SITE-1
configuration file appears in the list.
The possible field values are:
–
Running Configuration — Uploads the Running Configuration file.
–
Startup Configuration — Uploads the Startup Configuration file.
–
<filename> — Uploads the specified configuration file. The filename was determined by the
user at download.