User guide

222 Configuring System Information
• Supported IP Format — Specifies the IP format supported by the server. The possible values are:
–
IPv6 — IP version 6 is supported.
–
IPv4 — IP version 4 is supported.
•
IPv6 Address Type — When the server supports IPv6 (see previous parameter), this specifies the type
of static address supported. The possible values are:
–
Link Local — A Link Local address that is non-routable and used for communication on the same
network only.
–
Global — A globally unique IPv6 address; visible and reachable from different subnets.
•
Link Local Interface — When the server supports an IPv6 Link Local address (see previous
parameter), this specifies the the Link Local interface. The possible values are:
–
VLAN1 — The IPv6 interface is configured on VLAN1.
–
ISATAP — The IPv6 interface is configured on ISATAP tunnel.
•
Firmware Download — The Firmware file is downloaded. If Firmware Download is selected, the
Configuration Download fields are grayed out.
•
Configuration Download — The Configuration file is downloaded. If Configuration Download is
selected, the
Firmware Download fields are grayed out.
•
Download via TFTP — Enables initiating an image download via the TFTP server.
•
Download via HTTP — Enables initiating an image download via the HTTP server.
Firmware Download
• Server IP Address — The Server IP Address from which the firmware files are downloaded.
•
Source File Name (1-64 Characters) — Indicates the file to be downloaded.
Active Image
• Active Image — The Image file that is currently active.
•
Active Image After Reset — The Image file that is active after the device is reset.
Configuration Download
• Server IP Address — The Server IP Address from which the configuration files
• are downloaded.
•
Source File Name (1-64 Characters) — Indicates the configuration files to be downloaded.
•
Destination — The destination file to which the configuration file is downloaded.