User guide

210 Configuring System Information
Displaying all Communities
1 Open the SNMP Community page.
2 Click Show All.
The Community Table opens:
Figure 6-94. Community Table
Deleting Communities
1 Open the Community Table page.
2 Click Show All.
The Community Table opens.
3 Select a community from the Community Table.
4 Select the Remove check box.
5 Click Apply Changes .
The selected community entry is deleted, and the device is updated.
Configuring Communities Using CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the
Community Table page.
Table 6-44. SNMP Community CLI Commands
CLI Command Description
snmp-server community community [ro | rw | su] [ipv4-address | ipv6-address]
[view view-name] [type router | oob]
Sets up the community access string
to permit access to SNMP protocol.
snmp-server host {ipv4-address | ipv6-address | hostname} community-string [traps
| informs] [1 | 2] [udp-port port] [filter filtername] [timeout seconds] [retries retries]
Determines the trap type sent to the
selected recipient.