User guide

194 Configuring System Information
Table 6-41. LLDP Neighbors Information CLI Commands
The following is an example of the CLI commands:
Switch# show lldp neighbors
Defining SNMP Parameters
Simple Network Management Protocol (SNMP) provides a method for managing network devices.
Devices supporting SNMP run a local software (agent).
The SNMP agents maintain a list of variables, which are used to manage the device. The variables are
defined in the Management Information Base (MIB). The MIB contains the variables controlled by the
agent. The SNMP protocol defines the MIB specification format, as well as the format used to access the
information over the network.
Access rights to the SNMP agents are controlled by access strings. To communicate with the device, the
Embedded Web Server submits a valid community string for authentication. To open the SNMP page,
click System → SNMP in the tree view.
This section contains information for managing the SNMP configuration.
Defining SNMP Global Parameters
The SNMP Global Parameters page permits enabling both SNMP and Authentication notifications.
To open the SNMP Global Parameters page, click System → SNMP → Global Parameters in the
tree view.
CLI Command Description
show lldp neighbors
interface
Displays information about neighboring
devices discovered using Link Layer
Discovery Protocol (LLDP)
Port Device ID Port
ID
Hold
Time Capabilities
System
Name
1 0060.704C.73FE 1 117 B ts-7800-2
1 0060.704C.73FD 1 93 B ts-7800-2
2 0060.704C.73F C 9 1 B, R ts-7900-1
3
0060.704C.73FB 1 92 W ts-7900-2