User guide

122 Configuring System Information
– Delay — Indicates that the default gateway is no longer known to be reachable, and traffic has
recently been sent to the default gateway. Rather than probe the default gateway immediately,
however, there is a delay sending probes for a short while in order to give upper-layer protocols a
chance to provide reachability confirmation.
–
Probe — Indicates that the default gateway is no longer known to be reachable, and unicast
Neighbor Solicitation probes are being sent to verify reachability.
–
Unreachable — Indicates that no reachability confirmation was received.
•
Remove — When selected, removes the address from the list.
Adding an IPv6 Default Gateway
1 Open the IPv6 Default Gateway page.
2 Click Add .
The
Add IPv6 Default Gateway page opens:
Figure 6-31. Add IPv6 Default Gateway
3 Complete the fields on the page.
4 Click Apply Changes .
The new gateway is added, and the device is updated.
Defining IPv6 Default Gateway Parameters Using CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the IPv6
Default Gateway page.
Table 6-20. IPv6 Default Gateway CLI Commands
CLI Command Description
ipv6 default-gateway ipv6-address Defines an IPv6 default gateway.