User guide

104 Configuring System Information
– Warning — A system warning has occurred.
–
Notice — The system is functioning properly, but system notice has occurred.
–
Informational — Provides device information.
–
Debug — Provides detailed information about the log. If a Debug error occurs, contact Customer
Tech Support.
•
Delete Server — Deletes the currently selected server from the Available Servers list, when selected.
•
Severity to Include — Indicates the log severity level to be reported by the remote server. The possible
field values:
–
Emergency — The highest warning level. If the device is down or not functioning properly, an
emergency log message is saved to the specified logging location.
–
Alert — The second highest warning level. An alert log is saved if there is a serious device
malfunction, for example, all device features are down.
–
Critical — The third highest warning level. A critical log is saved if a critical device malfunction occurs,
for example, two device ports are not functioning, while the rest of the device ports remain functional.
–
Error — A device error has occurred, for example, if a single port is offline.
–
Warning — The lowest level of a device warning. The device is functioning, but an operational
problem has occurred.
–
Notice — Provides device information.
–
Informational — Provides device information.
–
Debug — Provides debugging messages.
The Remote Log Server Settings page also contains a severity list. The severity definitions are the same
as the severity definitions in the Global Log Parameters page.
When adding a Log Server, the following additional parameters are available:
• Supported IP Format — Specifies the IP format supported by the server. The possible values are:
–
IPv6 — IP version 6 is supported.
–
IPv4 — IP version 4 is supported.
•
IPv6 Address Type — When the server supports IPv6 (see previous parameter), this specifies the type
of static address supported. The possible values are:
–
Link Local — A Link Local address that is non-routable and used for communication on the same
network only.
–
Global — A globally unique IPv6 address; visible and reachable from different subnets.
•
Link Local Interface — When the server supports an IPv6 Link Local address (see previous
parameter), this specifies the the Link Local interface. The possible values are:
–
VLAN1 — The IPv6 interface is configured on VLAN1.
–
ISATAP — The IPv6 interface is configured on ISATAP tunnel.