Quick Reference Guide

VLAN Commands 491
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 – FOR PROOF ONLY
• tagged — Indicates that the port transmits tagged packets for the VLANs.
•
untagged — Indicates that the port transmits untagged packets for the VLANs.
Default Configuration
If the port is added to a VLAN without specifying tagged or untagged, the default setting
is tagged.
Command Mode
Interface Configuration (Ethernet, port-channel) mode.
User Guidelines
• This command enables changing the egress rule (e.g., from tagged to untagged) without first
removing the VLAN from the list.
Example
The following example adds VLANs 2, 5, and 6 to the allowed list of Ethernet port 1/e16 .
switchport general pvid
The switchport general pvid Interface Configuration mode command configures the PVID when
the interface is in general mode. Use the no form of this command to return to the default
configuration.
Syntax
• switchport general pvid vlan-id
• no switchport general pvid
• vlan-id — Specifies the PVID (Port VLAN ID).
Default Configuration
If the default VLAN is enabled, PVID = 1. Otherwise, PVID=4095.
Command Mode
Interface Configuration (Ethernet, port-channel) mode.
User Guidelines
There are no user guidelines for this command.
Console(config)# interface ethernet 1/e16
Console(config-if)# switchport general allowed vlan add 2,5-6
tagged