Quick Reference Guide

38 Command Groups
www.dell.com | support.dell.com
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 – FOR PROOF ONLY
ACL Commands
Address Table Commands
Command Group Description Access Mode
ip access-list Creates Layer 2 ACLs. Global
Configuration
permit (IP) Permits traffic if the conditions defined in the permit
statement match.
IP Access-List
Configuration
deny (IP) Denies traffic if the conditions defined in the deny
statement match.
IP Access-List
Configuration
mac access-list Creates Layer 2 ACLs. Global
Configuration
permit (MAC) Set permit conditions for a MAC access list MAC Access-List
Configuration
deny (MAC) Denies traffic if the conditions defined in the deny
statement match
MAC Access-List
Configuration
service-acl Sets the default ace action to permit or deny. Interface
Configuration
show access-lists Applies an ACL to the input interface. Privileged EXEC
show interfaces access-
lists
Displays ACLs defined on the device. Privileged EXEC
Command Group Description Access Mode
bridge address Adds a static MAC-layer station source address to the
bridge table.
Interface (VLAN)
Configuration
bridge multicast filtering Enables filtering of Multicast addresses. Global
Configuration
bridge multicast address Registers MAC-layer Multicast addresses to the
bridge table, and adds static ports to the group.
Interface (VLAN)
Configuration
bridge multicast forbidden
address
Forbids adding a specific Multicast address to specific
ports.
Interface (VLAN)
Configuration
bridge multicast
unregistered
Configures the forwarding state of unregistered
multicast addresses.
Interface
Configuration
bridge multicast forward-
all
Enables forwarding all Multicast frames on a port. Interface (VLAN)
Configuration