Quick Reference Guide

272 LLDP Commands
www.dell.com | support.dell.com
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 – FOR PROOF ONLY
Syntax
• lldp management-address ip ip-address
• no management-address ip
• ip-address — Specifies the management address to advertise.
Default Configuration
No IP address is advertised.
Command Modes
Interface configuration (Ethernet) mode.
User Guidelines
• Each port can advertise one IP address.
• Only static IP addresses can be advertised.
Example
The following example specifies management address that would be advertised from an interface.
lldp med enable
The lldp med enable Interface Configuration mode command enables Link Layer Discovery Protocol
(LLDP) Media Endpoint Discovery (MED) on an interface. Use the
no form of this command to
disable LLDP MED on an interface.
Syntax
• lldp med enable [ tlv1 … tlv3 ]
•
no lldp med enable
• tlv — Specifies TLV that should be included. Available TLVs are: network-policy, location,
poe-pse. The capabilities TLV is always included if LLDP–MED is enabled.
Default Configuration
LLDP is disabled.
Command Modes
Interface Configuration (Ethernet) mode.
Console(config)# interface ethernet g1
Console(config-if)# lldp management-address 192.168.0.1