Quick Reference Guide

LLDP Commands 271
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 – FOR PROOF ONLY
Usage Guidelines
• It is recommended that the TxDelay be less than 0.25 of the LLDP timer interval.
Examples
The following example specifies the delay between successive LLDP frame transmissions initiated by
value/status changes in the LLDP local systems MIB.
lldp optional-tlv
To specify which optional TLVs from the basic set should be transmitted, use the lldp optional-tlv
command in interface configuration mode. Use the
no form of this command to revert to the default
setting.
Syntax
lldp optional-tlv tlv1 [tlv2 … tlv5]
no lldp optional-tlv
• tlv — Specifies TLV that should be included. Available optional TLVs are: port-desc, sys-
name, sys-desc, sys-cap, 802.3-mac-phy.
Default Configuration
No optional TLV is transmitted.
Command Modes
Interface configuration (Ethernet)
User Guidelines
• There are no user guidelines for this command.
Example
The following example specifies which optional TLV (2)s from the basic set should be transmitted.
lldp management-address
The lldp management-address Interface Configuration mode command specifies the management
address advertised from an interface. Use the no form of this command to cease advertising
management address information.
Console (config) # lldp tx-delay 7
Console(config)# interface ethernet g1
Console(config-if)# lldp optional-tlv sys-name