Quick Reference Guide

GVRP Commands 201
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 – FOR PROOF ONLY
Command Mode
Interface configuration (Ethernet, port-channel) mode.
User Guidelines
• The following relationship must be maintained between the timers:
– Leave time must be greater than or equal to three times the join time.
– Leave-all time must be greater than the leave time.
• Set the same GARP timer values on all Layer 2-connected devices. If the GARP timers are set
differently on Layer 2-connected devices, the GARP application will not operate successfully.
Example
The following example sets the leave timer for Ethernet port 1/e6 to 900 milliseconds.
gvrp vlan-creation-forbid
The gvrp vlan-creation-forbid Interface Configuration (Ethernet, port-channel) mode command
disables dynamic VLAN creation or modification. Use the no form of this command to enable
dynamic VLAN creation or modification.
Syntax
• gvrp vlan-creation-forbid
• no gvrp vlan-creation-forbid
Default Configuration
Dynamic VLAN creation or modification is enabled.
Command Mode
Interface Configuration (Ethernet, port-channel) mode.
User Guidelines
• This command forbids dynamic VLAN creation from the interface. The creation or modification
of dynamic VLAN registration entries as a result of the GVRP exchanges on an interface are
restricted only to those VLANs for which static VLAN registration exists.
Console(config)# interface ethernet 1/e6
Console(config-if)# garp timer leave 900