Manualshelf

Quick Reference Guide

ManualsBrandsDell ManualsOtherPowerConnect 3548
181182183184185186187188189190
Ethernet Configuration Commands 185
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 – FOR PROOF ONLY
Default Configuration
The default setting is
on
.
Command Mode
Interface Configuration (Ethernet) mode.
User Guidelines
•
Auto:
All possibilities to connect a PC with cross or normal cables are supported and are
automatically detected.
•
On
: It is possible to connect to a PC only with a normal cable and to connect to another device
only with a cross cable.
•
No
: It is possible to connect to a PC only with a cross cable and to connect to another device only
with a normal cable.
Example
The following example enables automatic crossover on port 1/e5.
back-pressure
The back-pressure Interface Configuration (Ethernet) mode command enables back pressure on a
given interface. Use the no form of this command to disable back pressure.
Syntax
•
back-pressure
•
no back-pressure
Default Configuration
Back pressure is enabled.
Command Mode
Interface Configuration (Ethernet) mode.
User Guidelines
• Back pressure cannot be configured on trunks.
Console(config)# interface ethernet 1/e5
Console(config-if)# mdix auto