Quick Reference Guide

Address Table Commands 123
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 – FOR PROOF ONLY
Default Configuration
The default setting is 1 address.
Command Mode
Interface Configuration (Ethernet, port-channel) mode.
User Guidelines
This command is only relevant in dynamic learning modes.
Example
The following example sets the maximum number of addresses that are learned on port 1/e7 before
it is locked to 20.
port security routed secure-address
The port security routed secure-address Interface Configuration (Ethernet, port-channel) mode
command adds a MAC-layer secure address to a routed port. Use the no form of this command to
delete a MAC address.
Syntax
• port security routed secure-address mac-address
• no port security routed secure-address mac-address
• mac-address — A valid MAC address.
Default Configuration
No addresses are defined.
Command Mode
Interface configuration (Ethernet, port-channel) mode; cannot be configured for a range of
interfaces (range context).
User Guidelines
• The command enables adding secure MAC addresses to a routed port in port security mode.
• The command is available when the port is a routed port and in port security mode. The address
is deleted if the port exits the security mode or is not a routed port.
Console(config)# interface ethernet 1/e7
Console(config-if)# port security mode dynamic
Console(config-if)# port security max 20