Quick Reference Guide

118 Address Table Commands
www.dell.com | support.dell.com
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 – FOR PROOF ONLY
bridge multicast forward-all
The bridge multicast forward-all Interface Configuration (VLAN) mode command enables
forwarding all Multicast packets on a port. Use the no form of this command to restore the default
configuration.
Syntax
• bridge multicast forward-all { add | remove } { ethernet interface-list | port-channel port-
channel-number-list
}
•
no bridge multicast forward-all
• add — Force forwarding all Multicast packets.
•
remove — Do not force forwarding all Multicast packets.
•
interface-list — Separate non-consecutive Ethernet ports with a comma and no spaces; a
hyphen is used to designate a range of ports.
•
port-channel-number-list — Separate non-consecutive port-channels with a comma and no
spaces; a hyphen is used to designate a range of port-channels.
Default Configuration
This setting is disabled.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example forwards all Multicast packets on port 1/e8.
Console(config)# interface vlan 2
Console(config-if)# bridge multicast forward-all add
ethernet 1/e8